Deco M5 source signal selectable?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Is there an optimize command from the Deco App so that Deco slave units find their best signal source?
Is the signal source for slave decos selectable from the Deco App?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
"
Hi, Thank you very much for all the sharing.
The good news is that the new firmware 1.6.0 for Deco M5 would allow us to manually choose the signal source and it would be released very soon;"
What is your definition of very soon? You posted that on 2021-04-27. Today is 2021-07-06. This is stupid.
- Copy Link
- Report Inappropriate Content
And in the meantime we've got the 1.5.0 form 11.05.2021... Damn I need this feature!!
- Copy Link
- Report Inappropriate Content
This is really odd, last week I updated the firmware and had the option to manually change the network layout, but I had a power cut yesterday and the Deco's reset to all using the main hub as source signal. So I looked for the option to change the source signal again but it's gone... Whats going on here?
- Copy Link
- Report Inappropriate Content
Where was the option?
- Copy Link
- Report Inappropriate Content
I'm almost positive it was selectable from clicking on the Signal Source for the individual deco, but now I'm beginning to question myself!
- Copy Link
- Report Inappropriate Content
@TP-Link
Hello friends, I have the same problem as you, yesterday my network diagram seemed to be correct in a cascade connection, however I presented many problems of slowness in the satellite decos so the TPLINK support told me to delete the network and change it name and create another, I did that and the problem continues and today the network diagram without any explanation is different. I really don't know what else to do but my satellite decos are very slow.
Yesterday
Today
The DECOS are still in the same physical location as from when I bought and installed them.
I'm seriously thinking about buying a linksys velop
Regards,
César Vegas
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@TP-Link I am on firmware version 1.5.3 Build 20210203. Even on this firmware, the signal source is not selectable.
I tried running the suggested "Network Optimization", it did something for a minute, but nothing changed.
The 3rd Deco doesn't have signal source as 2nd Deco which is relatively closer than the 1st Deco.
3rd Deco still says signal source as 1st deco, and has weaker signal.
Could you please provide an alternative?
- Copy Link
- Report Inappropriate Content
When will this become official firmware ? It's been so long
- Copy Link
- Report Inappropriate Content
@TP-Link Hi, is there a beta firmware for X20 ?
i have the same issue, my first floor deco is getting connected to the 3rd florr Main Deco that has the Internet connection instead of the 2nd floor deco
please advise.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 52
Views: 122439
Replies: 333
Voters 39
