All, please see the thread on post #39 for the debugging software for MR600

Best to have the latest firmware installed anyway :-)  Here is the link.

https://www.tp-link.com/uk/support/download/archer-mr600/#Firmware

Good luck,

G.

@ Guillaume_1978  but with this firmware i've always disconnted of network every hours

@EctoZ Then you should follow the debugging process of post #39 and be in touch with the support team :-)

@Guillaume_1978 Ok you know why when i use the debubugging process my connection is 4G and not 4G+? Because before this process I'm in 4G+

@Guillaume_1978 @EctoZ 

I've checked out post #39 and found the two files:

Archer_MR600v1_1.1.0_0.9.1_[200117-rel34891]_up_boot_2020-01-17_10.08.32.bin - 16MB

Archer_MR600v1_1.1.0_0.9.1_[191106-rel78477]_up_boot_2019-11-11_14.38.49.rar - 37MB

Both are way smaller than the official release:

Archer_MR600v1_1.1.0_0.9.1_[190412-rel66770]_up_boot_2019-04-12_18.39.25.bin - 73MB

Given the filename: "FW_for_unstable_issue-Tool", I suspect this is not a full release at all and performs unnecessary workloads.

Why is it taking so long for them to fix this issue? A simple event = Disconnected should trigger a re-connect.

Tom

@Guillaume_1978 When I use tp-link LTE Log Tool I have this message "unable to read router's information!"

Guillaume_1978 wrote

 

Best to have the latest firmware installed anyway :-)  Here is the link.

https://www.tp-link.com/uk/support/download/archer-mr600/#Firmware

This latest firmware is also the oldest firmware

@Baenz do you have solution about this problem?