SNMP on Archer MR600. wrong OID?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

SNMP on Archer MR600. wrong OID?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
SNMP on Archer MR600. wrong OID?
SNMP on Archer MR600. wrong OID?
2020-03-20 18:55:37
Model: Archer MR600  
Hardware Version: V1
Firmware Version: 1.1.0 0.9.1 v0001.0 Build 190412 Rel.66770n

Hello,

 

I am trying to monitor the traffic on the router. Long time ago I learnt you should not trust that the ifIndex will not change, so I usually check the the WAN interface checking the default route interface, using IP-MIB::ip.ipRouteTableipRouteEntry.ipRouteIfIndex.0.0.0.0 (.1.3.6.1.2.1.4.21.1.2.0.0.0.0), but to my surprise this value is continously changing, actually it seems to be some counter. The rest of the IP-MIB::ip.ipRouteTableipRouteEntry tree seems to be right.

 

Do you know if this is a bug or simply TP-Link is using non-standard MIBs?

 

On the other hand, I expected to see at least four interfaces (wan-ethernet, lan-ethernet, wlan, 4G), but I can only see three ones, and also the admin/oper status of one of them is down, so, only two?

 

IF-MIB::ifDescr.2 = STRING: ifb0
IF-MIB::ifDescr.18 = STRING: ra2
IF-MIB::ifDescr.22 = STRING: eth1.5.0
IF-MIB::ifAdminStatus.2 = INTEGER: down(2)
IF-MIB::ifAdminStatus.18 = INTEGER: up(1)
IF-MIB::ifAdminStatus.22 = INTEGER: up(1)
IF-MIB::ifOperStatus.2 = INTEGER: down(2)
IF-MIB::ifOperStatus.18 = INTEGER: up(1)
IF-MIB::ifOperStatus.22 = INTEGER: up(1)

 

Can you give me a hint?

 

Thanks

//JM

  1      
  1      
#1
Options

Information

Helpful: 1

Views: 1118

Replies: 0