Archer C6 V2 Firmware 1.3.0 EU - WiFi drops every few minutes after firmware upgrade
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
I've updated my Archer C6 (v2.0) UK router to the latest firmware (1.3.0 Build EU 20200402 rel.52000). I'm fairly sure the old version was 1.2.1. After upgrading I've noticed all wireless (5Ghz & 2.4Ghz) clients randomly and continuously get dropped from the WiFi (I can see this happening on the devices and in the router's System Logs as DHCP requests). The drop affects one or more devices, every 1 or 2 minutes.
After discovering the problem I tried changing most settings to match those on https://emulator.tp-link.com/c6-eu-v2/index.html just to make sure it's not my configuration.
Is anyone else finding this issue with their C6 router using the new firmware?
The firmware release notes also say it's not downgradable, is this true?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi
Without any provision for a new OEM version by TP-LINK, I installed OPENWRT and then installed OEM version 1.2.1 again, this seems to me the most stable of all for me.
best regards
- Copy Link
- Report Inappropriate Content
Hi I buy new router the firmware upgrade same problem wifi drop every times
- Copy Link
- Report Inappropriate Content
Is there any possibilty of geting these beta firmware?
I've updated through router online update, and didn't know that you can't downgrade after this update. Now i have some wi fi drops, and whats worse frequent internet drops. Working from home became hell.
I'm at.
1.3.0 Build 20200402 rel.52000 - Archer C6 v2.0
Thanks
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
ok there is no solution,
so i sent back this s..., and buy a xiaomi 4a
- Copy Link
- Report Inappropriate Content
Hi guys, I just bought & installed the C6 V2 which came with 1.3.0 firmare preloaded; After 7 days experience, I have not experienced any dropping off of the WiFi signal, BUT, in the WiFi config panel, there is no way to change the mode, the channel width, or the channel (which is thus stuck on "1"). Apparently, according to earlier posts on this forum, these modifications were possible on earlier releases. I want to change the channel, as I have one "old" client which does not see the signal, whatever I do. Cheers ...
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
PM sent
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
PM Sent
- Copy Link
- Report Inappropriate Content
Information
Helpful: 2
Views: 39125
Replies: 99
Voters 2
