New TPLink AC1200 MR600 WLAN Routers Go dark

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

New TPLink AC1200 MR600 WLAN Routers Go dark

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
New TPLink AC1200 MR600 WLAN Routers Go dark
New TPLink AC1200 MR600 WLAN Routers Go dark
2020-09-03 11:04:52 - last edited 2020-09-08 07:20:08
Model: Archer MR600  
Hardware Version: V1
Firmware Version:

Several of these brand new modem/routers running on 4G+ went dark after two months with all top cover lights off. Power button in and unit powered. Internet found to be Offline. Simple reboot of power either by power button or power plug in/out fully restores each. Seems like a full cache issue given several fit at the same time in different locations hundreds of kilometers from eachother all went off the same day. Not a service outage. The dark indicators points to a lock up of a clock chip of sorts. Re-boot sorts all. Anybody else seen this? Firmware is the latest. Melbourne store purchase. 

  0      
  0      
#1
Options
1 Accepted Solution
Re:New TPLink AC1200 MR600 WLAN Routers Go dark-Solution
2020-09-08 07:19:49 - last edited 2020-09-08 07:20:08

@Shialude 

Good day.

Thank you very much for your time and patience.

How many Archer MR600 do you have and all of them had the same issue?

If possible, could you please record a video clip of the abnormal LED status

Have you ever tried to reset one of the MR600 by holding the reset pinhole/button at the back for 10s?

By the way, have you tried to set up the LED control or reboot schedule on the MR600 before?

Thank you very much.

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:New TPLink AC1200 MR600 WLAN Routers Go dark-Solution
2020-09-08 07:19:49 - last edited 2020-09-08 07:20:08

@Shialude 

Good day.

Thank you very much for your time and patience.

How many Archer MR600 do you have and all of them had the same issue?

If possible, could you please record a video clip of the abnormal LED status

Have you ever tried to reset one of the MR600 by holding the reset pinhole/button at the back for 10s?

By the way, have you tried to set up the LED control or reboot schedule on the MR600 before?

Thank you very much.

Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 389

Replies: 1

Related Articles