range not showing

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

range not showing

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
range not showing
range not showing
2020-10-05 13:24:09 - last edited 2020-10-07 06:06:17
Model: Archer MR200  
Hardware Version: V4
Firmware Version:

I am using the wifi router, suddenly the range stopped showing and disconnected. Then i restarted and resetted times, still it is the same. What shall I do now? Currently i'm away from the hoem, so please suggest me a way to support remotely

0
0
#1
1 Reply
Re:range not showing
2020-10-21 08:57:21

@customer2020 

Good day,

Thank you very much for your time and patience.

Sorry for the delay.

Have you come back home already?

When you mentioned the range stopped showing, did you see the wireless signal did not broadcast anymore, for both 2.4ghz and 5ghz?

How long have you had the device and where are you located?

 

Thanks a lot.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
0
0
#2