Set channell on Archer MR600

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Set channell on Archer MR600
Set channell on Archer MR600
2020-10-17 22:35:26 - last edited 2020-10-19 05:26:21

Hi guys i've buy a couple day ago an Archer MR600...but i don't find the for change the channel radio. This option is present on this device?If yes, where is it?

Thank u

0
0
#1
Options
3 Reply
Re:Set channell on Archer MR600
2020-10-21 05:58:38

@BullSlevin88 

Good day,

Thank you very much for your time and patience.

Sorry for the delay.

May I know why you want to change the channel radio

For the channel radio, do you mean the wireless channel and channel width, such as channel 1-13 for 2.4ghz, or LTE band, like band 1/3/40?

If it is the wireless channel, you could find it under advanced>wireless> wireless settings;

For the LTE band, you might need to install the beta firmware since the current official firmware is not supported manual band selection.

Thanks a lot.

1
1
#2
Options
Re:Set channell on Archer MR600
2020-10-24 11:50:17

@Sunshine thank u for the reply...yes I use the router with the LTE sim..so i think isn't impossible change the WiFi channel with this fw. About the beta fw can u pass me it? 

0
0
#3
Options
Re:Set channell on Archer MR600
2020-10-29 06:45:10

@BullSlevin88 

Hi!

The firmware which supports manual band selection has been sent and please have a check of your message box.

Thanks a lot.

0
0
#4
Options