switch 2nd port on Deco X60

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

switch 2nd port on Deco X60

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
switch 2nd port on Deco X60
switch 2nd port on Deco X60
2020-11-12 22:04:42
Model: Deco X60  
Hardware Version: V2
Firmware Version: 2.26

Hi

my setup

modem -- Deco x60 -- switch -- homelab devices(nas, solar monitoring unit ...)

rest of Deco x60 are on wifi backhaul.

so i am not trying to set up wired backhaul, just trying to get my lab devices accessible.

so wifi works just fine. i can not access anything that's connected to switch. i also see port lights are not green on switch either. i connected my laptop directly to switch for some troubleshooting, no luck, it is not fetching IP from Deco DHCP.

 

I like Deco x60 but if i can not make any of my devices work on wire, it breaks the deal for me.

i am replacing C4000 system, so fan of tplink product.

 

  0      
  0      
#1
Options
1 Reply
Re:switch 2nd port on Deco X60
2020-11-18 13:13:28

@kjp28 

Good day,

Did you enable the IPTV service on the main router?

If yes, then there would be no internet from the second Ethernet port of Deco X60 since it Is reserved for the IPTV service.

And if possible, you could turn off the IPTV, or connect the switch to the satellite Deco X60 to have a look.

Thank you very much.

  0  
  0  
#2
Options