Client Not Showing in Omada SDN
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.Client Not Showing in Omada SDN
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello,
I have a strange bug: I have a client (Raspberry Pi running Raspbian 10) that is not showing up in my client list on Omada. The client is located in "Clients 4" below:
I can ping the Omada SDN and TL-R605 successfully from this client, and it is functioning properly in my network.
Has anyone perhaps seen similar problems, or have any tips for debugging?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
I have the same issue but i am not using a TP-Link router.
My switch is constantly missing heartbeats which then shows 0 wired clients in the Omada SDN software.
I am running the TL-SG2428P v1.0 switch, my controller is virtual on Debian running 4.2.4
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
I just moved from a standalone TL-R605 (1.1) to an Omada Controller (4.4.8) and am facing the same issue now.
Wired clients are only showing up sporadically or not at all and I am unable to assign any fixed IP addresses (or at least it is not working) but at least dhcp seems to be working fine.
Did any of you guys get a working fix/info from TP-Link yet or was able to fix the issue?
- Copy Link
- Report Inappropriate Content
I am going to join the list of this.
Gateway - ER7206 Version 1.1.1
Switch - TL-SG3428 Version 1.0.0
Handful of EAPs.
Only a certain wired devices show up randomly. I went through and updated all TP-Link Devices. Not sure if there is something i missed in setup, or if I am in the same boat as everyone else that its a software issue.
- Copy Link
- Report Inappropriate Content
omada controller v5.0.29
tl-r605 v1 - firmware 1.1.1
t1500g-8t v2 - firmware 2.0.6
the same problem since my last post on march of 2021. the same problem, no fix yet.
- Copy Link
- Report Inappropriate Content
I have same issue with my set up. Some wired clients traffics history while all wireless clients works just fine.
Omada Controller version v5.0.30
Omada OC200 v1.0 - firmware 1.14.3
ER605 v1.0 - firmware 1.2.0
TL-SG2008P v2.0 - firmware 2.0.1
EAP245 v3.0 - firmware 5.0.3
- Copy Link
- Report Inappropriate Content
Same issue for me as well.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 2
Views: 6988
Replies: 18
Voters 1