After enabled wds option in Archer c6 no internet connection shows

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

After enabled wds option in Archer c6 no internet connection shows

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Nishant1607

2021-06-08 08:10:13 - last edited 2023-02-01 02:09:24

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2021-06-08

After enabled wds option in Archer c6 no internet connection shows

2021-06-08 08:10:13 - last edited 2023-02-01 02:09:24

Tags: #WDS/Range Extender Mode

Model: Archer C6

Hardware Version:

Firmware Version:

My first router is syroptech dual band and ip is 192.168.1.1..and second is tp-link archer c6 1200 ip is 192.168.0.1..connect both router with Lan...change ip of second router to 192.168.1.2..then disable dchp and then enable wds bridge..after doing all this no internet connection shows...what to do know plz suggest

1 Reply

terziyski

LV7

2021-06-08 19:14:09 - last edited 2021-06-09 04:57:00

Posts: 7133

Helpful: 5349

Solutions: 1210

Stories: 7

Registered: 2013-10-12

Re:After enabled wds option in Archer c6 no internet connection shows

2021-06-08 19:14:09 - last edited 2021-06-09 04:57:00

@Nishant1607

Use this guide for configuring WDS on C6. If no internet for the C6 connected devices (wired or wireless) reboot the main router, reboot the C6 after that and test again.

Now you can go to Advanced > Status > Wireless to check the WDS status. When the WDS status is Run, it means WDS bridging is successfully built.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".

After enabled wds option in Archer c6 no internet connection shows

After enabled wds option in Archer c6 no internet connection shows

Information

Voters 0

Tags