Router not working after Firmware update.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.Router not working after Firmware update.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello everyone, I just got a notification of a firmware update to
Archer A6(US)_V3_210513
Modifications and Bug Fixes:
1. Optimized the wireless.
2. Optimize network stability.
Notes:
For Archer A6(US) 3.0
Without thinking about it much, I just pressed the upgrade button. The upgrade process was shown and upon reaching 100 Percentage, on pc I got the "not able to reach website error".
I thought it needed some time to restart.
So even after waiting for 10+ minutes I was getting the same screen.
Then I turned off the router and turned it on again. But after turning it on, all 5 Lights on the router is on and there is no wifi and I can't do much on pc either.
All it is showing in pc is that a line is plugged in.
How bad this situation is, how can I recover from this?
Any help is greatly appreciated.
Thank you.
Edit. I forgot to add that, I already tried to reset the router by holding on the reset button for 10 seconds. Doing this shows no response on the device. And is behaving just like it was doing before.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
RandomPerson1 wrote
So after going back to step 4, selecting the zip file and clicking I'm back to step 4.
Probably this is just a misspelling and you are actually doing it right, but anyway I'd like to remind that you need to extract the contents of the zip file to your computer's hard disk and then select the file "a6c6_v3-up-ver1-0-10-P1[20210513-rel63256]_2021-05-13_17.34.01.bin" at the "New Firmware File:" prompt.
- Copy Link
- Report Inappropriate Content
@woozle Yes this is exactly how I did it.
Unzip the zip file I have downloaded.
Browse for the bin file and clicked on upgrade.
Then the upgrade process starts and completes to 100 % and then suddenly I am taken back to the page where I select bin file.
- Copy Link
- Report Inappropriate Content
I noticed that initially you had the Archer A6(US)_V3_201117 release before that happened.
Have you tried to update with the same FW version instead ?
If that doesn't help too, then like I posted, try to contact your local support or the retailer.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2841
Replies: 13
Voters 0
No one has voted for it yet.