Mike2608

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Mike2608
Mike2608
2013-03-14 04:31:32
Region : UnitedKingdom

Model : TL-PA251KIT

Hardware Version : V1

Firmware Version :

ISP :


Region : UnitedKingdom

Model : TL-PA251KIT

Hardware Version : V1

Firmware Version :

ISP : Sky


i have a tp-link pa251 kit. I plugged it all in as instructed. When it came to connecting my laptop via the ethernet cable it would not connect to the internet. Do i need to alter settings on my laptop or have i set it up incorrectly? I get 3 green lights on each powerline adaptor so as far as i can tell the powerline is working. Any thoughts would be welcome
0
0
#1
Options
4 Reply
Re:Mike2608
2013-03-14 09:31:12
Firstly, please check the IP address on the laptop, since the powerline adapters has been connected with the middle light lit up, you need to make sure there is an IP address, if no, give a try to set a static IP address for the Local Area Connection.
0
0
#2
Options
Re:Mike2608
2013-03-14 20:10:22
If the powerline lights are on its just like using a wire between you and the router. Get in working first with a wire first if in doubt, Your laptop must be set to DHCP, or if static set to the same subnet the router is using.
0
0
#3
Options
Re:Mike2608
2013-03-21 19:23:54
I have a very similar problem only when I change the IP address on the TP powerline router it doesn't appear to accept it. I've tried contacting TP support but no response.
0
0
#4
Options
Re:Mike2608
2013-03-27 20:32:22
Put the two powerline adapters close to each other. And press the pair button of one of the adapters, and hold on it for 3-8 seconds and release it. Go to the second, do the same thing: press and hold on the pair buttin for 3-8 seconds.
And you can put the adapters where there were or where you want.
0
0
#5
Options
Related Articles