TL-WPA4220
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi There, I have an existing powerline network of three TL-PA4010P adapters to extend my wired connection around the house. They are working just fine. I have now purchased a single wireless adapter (TL-WPA4220) just to extend my wifi in a spare bedroom. I was under the impression these adapters are compatible with each other. However, I have tried everything possible but I am unable to get the powerline LED to activate on the new adapter. Any ideas if I'm doing something wrong??
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@BobbyBunny Finally figured it out.......... Once the TL-WPA4220 is plugged in and powered up, press and hold the wifi button to switch off the wifi facility. The green wifi LED will go off. Then 'pair' the TL-WPA4220 with one of the existing adapters. Once completed, the powerline LED should then be on. Re-activate the wifi functionality be pressing and holding the wifi button until the green wifi LED is on.......job done!
- Copy Link
- Report Inappropriate Content
@BobbyBunny Finally figured it out.......... Once the TL-WPA4220 is plugged in and powered up, press and hold the wifi button to switch off the wifi facility. The green wifi LED will go off. Then 'pair' the TL-WPA4220 with one of the existing adapters. Once completed, the powerline LED should then be on. Re-activate the wifi functionality be pressing and holding the wifi button until the green wifi LED is on.......job done!
- Copy Link
- Report Inappropriate Content
Hi
I have exactly the same problem with TL-WPA220 just bought, that I'm trying to pair with my existing TL-PA4010P. You suggest to push and hold the wifi button, but what do you mean with wifi button? You mean the pairing button? Otherwise, I can't see a WiFi button on my device.
Thanks for your help
F
- Copy Link
- Report Inappropriate Content
@FDemi Look at the front of the device at the green wifi LED. Carefully run your finger across the front of it and you will feel a slightly raised edge. That is the button. Not the pairing button on the underside.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1038
Replies: 4
Voters 0
No one has voted for it yet.