Home Network Community > Wi-Fi Routers > Static Ip problems
< Wi-Fi Routers

Static Ip problems

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Static Ip problems

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Static Ip problems
Static Ip problems
2021-11-03 07:25:45 - last edited 2021-11-04 00:50:16
Model: Archer A2300  
Hardware Version: V2
Firmware Version: !.1.1

I have an Archer AC2300 & i am trying to set it to Static ip.

It is connected to a Virgin Hub 4 1000mbs

If i set it to Static in Advanced/Network/internet using same ip as listed in dynamic mode it will no longer connect to internet despite it showing as ok on Status page?

Tried rebooting both hub & router with no effect.

What am i doing wrong please

  0      
 
  0      
 
#1
Options
3 Reply
Re:Static Ip problems
2021-11-04 06:47:13

@Fahl 

 

Why do you want to use a Static IP on the router Internet page? Basically, if you are able to obtain an IP address from the Virgin Hub 4 automatically, there is no need to use a static one.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX55V2 Supports WireGuard VPN, EasyMesh Ethernet Backhaul, IoT Network, Speed Limit,and More If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.
  0  
  0  
#2
Options
Re:Static Ip problems
2021-11-04 06:49:49

@Fahl 

Been advised to by Tp-Link otherwise Port Forwarding wont work (which it doesnt)

  0  
  0  
#3
Options
Re:Static Ip problems
2021-11-04 08:46:11 - last edited 2021-11-04 09:01:01

@Fahl 

 

If your ISP provides you with a dynamic public IP address then you can't use a static WAN IP address configuration.

If that's the case, for a port-forwarding to work, you should configure NO-IP.COM account and bind the this account to your router - see details here.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 659

Replies: 3

Related Articles
Static ip
607 0
PPPoE to Static IP
1419 0
Static IP on the MESH
67 0
 Combine static IP-address for cabled and wifi connections
416 0
Deco X50 static IP
1187 0
Can't set static ip
1139 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.