AC2300 cannot access GUI administration

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

AC2300 cannot access GUI administration

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
AC2300 cannot access GUI administration
AC2300 cannot access GUI administration
2021-11-27 16:46:27
Model: Archer C2300  
Hardware Version: V1
Firmware Version: 2.0.3 Build 20180810 Rel. 62903

Since I've bought this router I have same problem and last year support has temporarily solved problem by installing at that time "experimental" firmware as they told me.

I've bought three days ago this router and I've put it behind UBEE cable modem/router which is in bridge mode. Router seems to work OK but I'm unable to login via admin page nor via Tether app. When I press Log In on the page, cursor is spinning for 10 seconds and then stops but doesn't log me in. Similar is with Tether App. When I switch router off and then on I can log in but after short period (~10-20min to few days) again I have same behaviour and I'm unable to log in.

 

Does anybody had similar problem?

  0      
  0      
#1
Options
3 Reply
Re:AC2300 cannot access GUI administration
2021-11-27 17:01:16

@Fudodudo Does this happen on all connected devices or just some? If so, have you tried to factory reset the router?

  0  
  0  
#2
Options
Re:AC2300 cannot access GUI administration
2021-11-28 09:13:35
From neither one device I cannot login to the router until I turn it off and then on. After that login works normally but not forever. After some time it happens again.
  0  
  0  
#3
Options
Re:AC2300 cannot access GUI administration
2021-11-28 14:15:43

@Fudodudo Have you tried to factory reset the router? If you did and didn't help, I'd return it if it's still covered under warranty.

  0  
  0  
#4
Options

Information

Helpful: 0

Views: 474

Replies: 3

Related Articles