I cannot connect to my port forwarded server

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

I cannot connect to my port forwarded server

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I cannot connect to my port forwarded server
I cannot connect to my port forwarded server
2021-12-17 07:56:40
Model: TL-MR150  
Hardware Version: V2
Firmware Version: 1.0.0 0.9.1 v0001.0 Build 210115 Rel.62618n

Hi, as the title says I current am not able to connect to my server, the server uses port 19132; I used my public IP address and external port to connect to the server but no avail.

 

 

I've tried turning on DMZ and still I can't connect. I made sure that I am connecting using the public IP and Exposed Port of the server. 

 

Here is the settings of my current config

 

Advanced/Network/Internet

NAT: Switched ON

 

Server PC Network Info

IP ADDRESS: 192.168.1.100

Port Used: 19132

FIREWALL: OFF

 

Advanced/Nat Forwarding/Virtual Server Configuration
Virtual Server Configuration

Service Type: Test Connection

External Port: 19132

Internal IP: 192.168.1.100

Internal Port: 19132

Protocol: TCP or UDP

FIREWALL: OFF

 

 

  0      
  0      
#1
Options
1 Reply
Re:I cannot connect to my port forwarded server
2021-12-22 11:40:51

@internetlord 

 

Make sure that your public IP address is displayed here:

 

 

If you public IP address is different than the IP address from your router's interface above, that means your ISP probably uses CG-NAT.

If that's the case, then that's the reason you can't access your server from Internet.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 332

Replies: 1