Archer C60 Slow Upload Speed
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello
I am from India, my ISP is ACT Fibernet
My connection package is 75Mbps U/D
When I connect the LAN cable from my ISP's network switch directly to my laptop, I get the rated speed of 75 for both U and D, infact a little more than that on SpeedTest
However since last 1 week, my upload speed has not been going above 1Mbps. Tested with an Old Netgear router, the U/D were ~40Mbps so I am pretty sure theres some fault wiht the C60.
Please guide, thank you!
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hello, please refer to the troubleshooting guide we provided in the below link to review all the settings on the C60, especially the QoS settings:
https://community.tp-link.com/en/home/forum/topic/269726
- Copy Link
- Report Inappropriate Content
Hi thanks for your reply. I have tried all those steps, unfortunately thats not working for me. I have also tried a hard reset, even that hasnt solved the issue.
Please guide further, thank you
- Copy Link
- Report Inappropriate Content
Thank you. Can I have the QoS settings of the C60? Have you ever tried to reset the C60 to factory defaults then reconfigure it from scratch? When the upload speed is limited to 1Mbps, are you able to open websites?
- Copy Link
- Report Inappropriate Content
Yes I have done a factory reset, but the issue does not get solved. Websites open fine since the download speed isnt effected. But yes when I do videocalls or try to upload things, thats when it takes ages. Below are the QoS settings I tried as per the AX1110 router troubleshoot you showed me
- Copy Link
- Report Inappropriate Content
It seems the web GUI of the C60 is different from that of the AX11000, you can try to uncheck "Enable QoS", then reboot the router and confirm.
BTW, I've forwarded your case to the TP-Link support team who have tried to contact you with your registered email address, please pay attention to your email box for follow-up.
- Copy Link
- Report Inappropriate Content
It was disabled by default, which I then enabled as per the other router's guide you mentioned. I have disabled it again and rebooted but no change.
- Copy Link
- Report Inappropriate Content
Thanks. Please reply the email that sent to you, then the support engineers will try to investigate.
- Copy Link
- Report Inappropriate Content
Hi,
I'm using Archer C6 router and my service provider is ACT fibrenet (India)
Firmware version: 1.3.6 Build 20200902 rel.65591(4555)
Hardware version: 2.0
Broadband plan details : 300 Mbps (upload and download)
From past 1 week im getting very slow upload speed. As slow as 1 to 2 Mbps. Download speeds are around 300 Mbps on average.
I have tried Factory restore of the router , Manual firmware upgrade and reconfiguring the router. Nothing worked out. Im still facing the same issue as yours.
I dont think this is a hardware issue. This is something related to software broke somewhere which TP link needs to address this by providing the firmware update OTA.
Thanks
SRN
- Copy Link
- Report Inappropriate Content
Hey,
My issue is resolved by doing simple steps. Im not 100% sure that those steps fixed the issue but that is the only change i did after which it started working fine.
Go to 192.168.0.1 ---> Advanced ----> system tool -----> System Parameters
Check for RTS Threshold value
if it is 2346 then change it to 2304 and after sometime change it back to 2346.
And that fixed my issue.
Thanks
Srn
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1073
Replies: 9
Voters 0
No one has voted for it yet.