AX5400 One mesh option

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

AX5400 One mesh option

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Hughseee

2022-01-13 23:11:47

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2022-01-13

AX5400 One mesh option

2022-01-13 23:11:47

Model: Archer AX73

Hardware Version: V1

Firmware Version:

Hi there, I can’t seem to find this in the instruction manual...

if I don’t have any repeaters or access points, should I turn off the One Mesh option? It is enabled by default.

are there any pros or cons of disabling it?

1 Reply

terziyski

LV7

2022-01-14 00:43:49

Posts: 7142

Helpful: 5361

Solutions: 1220

Stories: 7

Registered: 2013-10-12

Re:AX5400 One mesh option

2022-01-14 00:43:49

@Hughseee

Go through this thread and decide for yourself.

My general rule is - if you don't use it then turn it off.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".

AX5400 One mesh option

AX5400 One mesh option

Information

Voters 0

Tags