No ip on TL-SG1008P

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

No ip on TL-SG1008P

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
No ip on TL-SG1008P
No ip on TL-SG1008P
2022-02-16 13:11:02
Model: TL-SG1008P  
Hardware Version: V6
Firmware Version: Unknown

Hello

I have been trying to set up the POE switch in order to power and recieve data from 2 ip cameraes. The problem i am facing is the switch not having any ip adress. When i plug my labtop and cameraes into the switch it will not give an ip adress, however when i plug in an ethernet cable connected to the router i will get an ip adress. Can i not use the POE switch to connect my labtop and cameraes without having the switch hooked up to an ethernet cable with internet?

Best Regards.

  0      
  0      
#1
Options
1 Reply
Re:No ip on TL-SG1008P
2022-02-16 23:53:55

  @iotboy 

 

This switch is unmanaged, i.e it won't get any management IP address. It's a plug&play device.

Here's the typical usage:

 

For non-PoE devices (like your laptop) use a port within range 5-8.

If this was helpful click on an arrow pointing upward. If this solves your issue, click the star to mark it as a "Recommended Solution".
  1  
  1  
#3
Options

Information

Helpful: 0

Views: 338

Replies: 1

Related Articles