CPE510 and several cameras

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

CPE510 and several cameras

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
CPE510 and several cameras
CPE510 and several cameras
2022-03-07 18:58:11
Model: CPE510  
Hardware Version: V3
Firmware Version:

Hello I have an instalation with several ip cameras in diferent buildings at diferent heights, I was think in the folowing conection all made with cpe510

Does this gone work or do anyone have some better sugestions.

Thank You

  0      
  0      
#1
Options
5 Reply
Re:CPE510 and several cameras
2022-03-08 12:13:01

Dear @Mikera

 

Mikera wrote

Hello I have an instalation with several ip cameras in diferent buildings at diferent heights, I was think in the folowing conection all made with cpe510

Does this gone work or do anyone have some better sugestions.

 

Looking at the pictures you have provided, it is basically possible to set it up in this way, but there are a few points to note.
1. CPE510 is not recommended to be set to REPEATER mode, you can install two CPEs in the bridge location and connect them with a network cable, such as AP CPE))) ((Client CPE - AP CPE))) ((Client CPE.

 

2. The antenna angle of the CPE510 is limited, so be careful when configuring a point-to-multipoint topology to place multiple Client CPEs at the opposite end within the antenna angle of this AP CPE.

 

3. This article is for your reference: https://www.tp-link.com/configuration-guides/common-applications-for-pharos-products/?configurationId=22033

 

Best Regards!

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  1  
  1  
#2
Options
Re:CPE510 and several cameras
2022-03-08 17:16:14
Thank you for the answer, maybe is better to put an wbs510 with a sector antenna instead of the cpe510, the antenna gives me a 120º radius I think??
  0  
  0  
#3
Options
Re:CPE510 and several cameras
2022-03-09 06:50:54

Dear @Mikera ,

 

Mikera wrote

Thank you for the answer, maybe is better to put an wbs510 with a sector antenna instead of the cpe510, the antenna gives me a 120º radius I think??

 

The WBS product is very old and a newer product is still recommended.

 

Best Regards!

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  1  
  1  
#4
Options
Re:CPE510 and several cameras
2022-03-09 18:01:59 - last edited 2022-03-09 18:02:25

  @Hank21 

What product would you recommend instead the wbs510.

Thank you

  0  
  0  
#5
Options
Re:CPE510 and several cameras
2022-03-10 06:14:29

Dear @Mikera ,

 

Mikera wrote

  @Hank21 

What product would you recommend instead the wbs510.

Thank you

 

If you don't require much in the way of internet speed, the CPE210 might be a little better, with a relatively larger antenna angle: 60 degrees.

 

Best Regards!

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#6
Options