Create a phone socket (RJ11) from a MR600 4G Router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Create a phone socket (RJ11) from a MR600 4G Router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Create a phone socket (RJ11) from a MR600 4G Router
Create a phone socket (RJ11) from a MR600 4G Router
2022-04-13 10:58:21
Model: Archer MR600  
Hardware Version: V1
Firmware Version:

Hi, i have recently set up an office in a remote location using the MR600 router for internet connection. I purchased a Yale alarm system which requires a phone connection to alert you of any intruders but it requires an RJ11 phone connection to work. 

 

Basically i need to create a phone line using my 4G router but i'm not sure how to do this. 

 

I notice that i can purchase an adapter on Amazon as per the below:

 

 

Is this the answer or will something further be needed? Something tells me its probably not as simple as this ;)

  1      
  1      
#1
Options
1 Reply
Re:Create a phone socket (RJ11) from a MR600 4G Router
2022-04-18 03:48:53

  @Quanto 

 

Hi, 

Actually It depends on your alarm system, it is recommended to confirm with the support of your alarm system to see if it will this way.

The MR600 Ethernet ports are the same as other normal router, and if possible, you could also check if the alarm system works this way with other router.

  0  
  0  
#2
Options

Information

Helpful: 1

Views: 392

Replies: 1