Home Network Community > Wi-Fi Routers > Only first light and last lights are on, unable to connect
< Wi-Fi Routers

Only first light and last lights are on, unable to connect

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Only first light and last lights are on, unable to connect

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Only first light and last lights are on, unable to connect
Only first light and last lights are on, unable to connect
2022-05-21 09:31:42
Model: Archer A6  
Hardware Version:
Firmware Version:

Only first light and last light are on, unable to connect

  0      
 
  0      
 
#1
Options
1 Reply
Re:Only first light and last lights are on, unable to connect
2022-05-21 15:32:36

  @ConfigureRouter 

 

If the two "Wi-Fi" LEDs are off, then it means Wi-Fi is currently disabled.

 

Your router should have a button labeled "WPS/Wi-Fi" on the rear side. Push this button for about 3 seconds and see if the Wi-Fi LEDs come on after that.

 

If this does not work either, then you could try if a "factory defaults restore" solves the problem. You do that by pressing and holding the small recessed "Reset" button for about 5 seconds. (you can release the button once you notice some response from the router's LEDs) 

  2  
  2  
#2
Options

Information

Helpful: 0

Views: 1132

Replies: 1

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.