MR600 showing one bar and end bar lit

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

MR600 showing one bar and end bar lit

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
MR600 showing one bar and end bar lit
MR600 showing one bar and end bar lit
2022-06-04 15:28:10
Model: Archer MR600  
Hardware Version: V2
Firmware Version:

Placed sim etc and turned on. What's odd is that on the signal strength indicator the first and last bar are lit but not the ones in between? 

 

What does this indicate? 

Tried live chat and after resetting etc they didn't have a clue. 

 

Could someone else help? 

  0      
  0      
#1
Options
1 Reply
Re:MR600 showing one bar and end bar lit
2022-06-07 03:09:47

  @Sroo 

Hi, thank you very much for the feedback.

It is indeed quite odd that only the one in between is off. Could you please send us a picture of the LEDs and also a screenshot of Advanced->Status page where we could check signal strength etc.?

 

In addition, may I know when you purchased this MR600? and did this problem start happening since purchase or just recently?

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options