MR600 (v2) Remote management works only on standard (443) port
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello,
I can get Remote Management via standard 443 HTTPS, but if I choose another (non standard) port, the connection will time out.
Any idea why it happens?
Kind regards,
LP.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi, may I know if your MR600 is working on 3G/4G Router mode or Wireless Router mode? And is the WAN IP disaplyed on Internet part of Advanced->Status page a public IP address?
Besides, please note that after you change the remote management page, you will need to use WAN IP:port number to access the web interface remotely.
By the way, may I know which port you've tried? please also make sure there is no conflict with any local servers if you have.
- Copy Link
- Report Inappropriate Content
HI Sunshine,
It works in 3/4G mode. The WAN IP is a public IP address.
Thereof I could do management as https://public.ip/ when I set it up on port 443
But it did not worked as https://public.ip:3443/ etc when I set the port as 3443, 3333, 8443, 3883
Same issue with VPN - works on standard port 1194 but not on other ports :(
Thanks!
- Copy Link
- Report Inappropriate Content
Hi, thank you very much for the reply.
May I know who is the Carrier of your SIM card? please try to contact the carrier to see if they have blocked the nonstandard ports from their end.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 544
Replies: 4
Voters 0
No one has voted for it yet.