Loopback don't work

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Loopback don't work

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Loopback don't work
Loopback don't work
2022-06-23 13:09:22
Model: TL-MR6500v  
Hardware Version: V1
Firmware Version:

Hi,

 

I use TP Link DNS service to connect from internet to my cam.

This works fine with my DNS Name "xyz.tplinkdns.com" from internet.

If I logged in localy, ep. with my Notebook it does not work with the same config.

 

Does Loopback not work or what is happend ?

 

regards

Conny

  0      
  0      
#1
Options
1 Reply
Re:Loopback don't work
2022-06-24 05:40:37

  @Conny64 

 

Hi, thank you very much for the feedback.

Is your MR6500v working on 3G/4G Router mode or Wireless Router mode? and is the WAN/Internet IP address on Advanced->Status page a public or private address?

 

Please try to use the WAN/Internet IP address to access the web interface from the same LAN network to see if it works.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 349

Replies: 1

Related Articles