Home Network Community > Wi-Fi Routers > Nano router connected to Internet but cannot ping in Diagnostics page
< Wi-Fi Routers

Nano router connected to Internet but cannot ping in Diagnostics page

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Nano router connected to Internet but cannot ping in Diagnostics page

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Nano router connected to Internet but cannot ping in Diagnostics page
Nano router connected to Internet but cannot ping in Diagnostics page
2022-08-25 23:51:41
Model: TL-WR802N  
Hardware Version:
Firmware Version:

Hello,

 

I use my nano router to connect my CCTV box to my  home wireless network using a wired connection.

 

Since my last broadband router reboot I've lost connection to the CCTV so I reset my nano router and tried to set it up again. However I can't seem to get it working.

 

If I wire it to my laptop and turn my WiFi off I can access the internet through the device but when I try to ping Google.com's IP in the Diagnostics page it times out.

 

Any suggestions?

 

Thanks,

 

Zak

  0      
 
  0      
 
#1
Options
2 Reply
Re:Nano router connected to Internet but cannot ping in Diagnostics page
2022-09-02 21:48:58

Bump

  0  
  0  
#2
Options
Re:Nano router connected to Internet but cannot ping in Diagnostics page
2022-09-03 21:18:13

  @Zak247 

 

Could you please share some information how you've setup the TL-WR802N?

 

I guess you have set the operation mode to "Client".

What about LAN Type? Static IP or Smart IP? If Static IP, have you set an unused IP address that is in the same subnet as the main router?

Is DHCP enabled or disabled?

 

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 322

Replies: 2

Related Articles
Can't access the internet in client mode
11187 0
About Us
Press
Copyright © TP-LINK CORPORATION PTE. LTD. All rights reserved.