@PapaJD 

 

So, is everything good now with Internet connection?

Internet on PC at node 3, but not on MIRA X box for TV.

  @PapaJD 

 

I have different brand of Android TV box, not MIRA, and in mine I had to open Network configuration settings, enable Ethernet and disable WiFi to force my TV box use wired connection.

Check your MIRA X box configuration settings, if it does not have anything for enabling/disabling Ethernet see if disabling WiFi will force it to use Ethernet cable.

Its MiraX HiS-3000 - Amiko Set-Top Box

I don't know how to configure the Mira Box. It has been working - and still works with just the Powerline adaptor.

  @PapaJD 

 

I see. MiraX HiS-3000 is Linux, not Android. Documentation I found says it has Ethernet port and it can have add-on WiFi adapter, but by default it only comes with Ethernet connectivity.

 

See if you can do reboot from its menu, or worst case - try factory reset. I am not familiar with that device, you might get more support on MiraX HiS-3000 support forums. You helped me to verify, with PC, that you can have Ethernet connection to Node 3. Why MiraX HiS-3000 can't connect, while PC can - that I would not tell.

 

I can give you few hints later today or tomorrow on how you may be able to improve WiFi and Internet speeds on Node 2 and Node 3, but I have to leave now. What I want to ask you, if you are interested in that, to make screenshot of Node 2 page in Deco app and post in your reply. Same screenshot you did for Node 3, but now for Node 2. 

It'll give me good understanding of your Deco WiFi mesh and possible way to improve its performance.

PapaJD wrote

I don't know how to configure the Mira Box. It has been working - and still works with just the Powerline adaptor.

  @PapaJD 

 

The simplest troubleshooting option would be to power it off, by unplugging its power cord, wait for about 5 minutes, connect it by Ethernet cable to Node 3, plug power cable back to Mira box and power it on.

 

I have to leave now. Talk to you later.

Alexandre, I'm not going to make changes to the Mira Box, it is working well with powerline adaptor and i dont want to interfere with it. I dont understand why it works with direct connections and not through Deco. I will send Node 2 shot later. Thanks again. JD

Hi Alexandra Just sent node2 screenshot. No success powering off mira box. JD.

  @PapaJD 

 

PapaJD wrote

Hi Alexandra Just sent node2 screenshot. No success powering off mira box. JD.

 

I haven't got Node 2 screenshot. Nothing is attached to your reply. 

Can you try sending again? You can also put screenshot inside the message, using "Image" button instead of "File" button.