Home Network Community > 5G/4G Wi-Fi Routers/MiFi > No 3G Data. Every time Requires 2 times reboot to get 3G data connection.
< 5G/4G Wi-Fi Routers/MiFi

No 3G Data. Every time Requires 2 times reboot to get 3G data connection.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

No 3G Data. Every time Requires 2 times reboot to get 3G data connection.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
No 3G Data. Every time Requires 2 times reboot to get 3G data connection.
No 3G Data. Every time Requires 2 times reboot to get 3G data connection.
2022-11-26 11:17:13
Model: Archer MR600  
Hardware Version: V2
Firmware Version: 1.6.0 0.9.1 v0001.0 Build 220105 Rel.58321n

Hi I have purchased the TP-Link Archer MR600 v2 from official partner on 19 November 2022.

 

Tested 4G+ connectivity results ok.

 

Tested 3G Connectivity with BSNL 3G sim 

Results are :

Max Speed       : 14 Mbps

Signal strength : 100%

RSSI                 : -62dBm

Network type:    : WCDMA

 

Problem :  Every time needs to reboot router at least 2 times to get connection to 3G network.

 

1 st boot  :  Internet Status:  Disconnected . No data. No Internet symboled light. Signal strength 3 bars .

2 nd boot :  Internet Status:  Disconnected . No data. No Internet symboled light. Signal strength 3 bars.

3 rd boot  :  Internet Status:  Connected .     Internet Connected Successfully.  

 

4 th boot  :  Internet Status:  Disconnected . No data. No Internet symboled light. Signal strength 3 bars .

5 th boot :   Internet Status:  Disconnected . No data. No Internet symboled light. Signal strength 3 bars .

6 th boot  :  Internet Status:  Connected.       Internet Connected Successfully.

 

  0      
 
  0      
 
#1
Options
3 Reply
Re:No 3G Data. Every time Requires 2 times reboot to get 3G data connection.
2022-11-28 02:34:13

  @Sumant_Gurjar 

 

Hi, when you tested 3G connection, was the network mode set to be 4G preferred to 3G only?

Please try to set it on 3G only to see if internet works fine on the first booting.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options
Re:No 3G Data. Every time Requires 2 times reboot to get 3G data connection.
2022-11-28 05:59:00 - last edited 2022-11-28 06:00:37

  @Sunshine 

 

Previous             Network Mode: 4 Preferred

 

New Setting      Network Mode:    3G Only

                           Internet Status:    Disconnected

                           Signal Strength:   100%

 

After applying the new setting I lost the internet connectivity on all time, all reboots, permanently.

Problem still exists. Requires 2 reboots and 4G preferred mode as it is.

 

Please check and suggest if its a hardware problem or a software bug ?

  0  
  0  
#3
Options
Re:No 3G Data. Every time Requires 2 times reboot to get 3G data connection.
2022-11-29 06:40:23

  @Sumant_Gurjar 

 

Hi, the testing BSNL SIM card only supports up to 3G, no 4G supported, right? Please share with us a system log file on first boot.

If you use the 4G SIM card to test 3G connection under 3G only mode, will it work without reboot?

 

After that, please email support.forum@tp-link.com with forum ID 590256 and provide us the following information:

1. Screenshot of Status page and system log file after first boot, please save the log after 5 minutes

2. 3G connection test results with another 4G SIM card under 3G only mode

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 615

Replies: 3

Related Articles
 WIFI Router requires reboot every time after connection drops
5126 3
 Router unresponsive after some time, requires manual reboot
438 0
2 times RE305
430 0
 MR600 3G Signal dropping at random times
645 0
 Allow List should be saved. Currently requires reconfiguration every time.
509 1
 Get 3G/4G status data in JSON format
505 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.