Home Network Community > Wi-Fi Routers > Archer C6- in AP-Mode: Speed through router is capped at 10Mbps
< Wi-Fi Routers

Archer C6- in AP-Mode: Speed through router is capped at 10Mbps

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer C6- in AP-Mode: Speed through router is capped at 10Mbps

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer C6- in AP-Mode: Speed through router is capped at 10Mbps
Archer C6- in AP-Mode: Speed through router is capped at 10Mbps
2022-12-05 13:15:53 - last edited 2022-12-06 02:51:25
Tags: #Access Point Mode
Model: Archer C6  
Hardware Version: V2
Firmware Version: 1.3.7 Build 20220613 rel.64828(4555)

Hello,

 

I need help. I run the Archer C6 in AP mode.

 

For a few days I've only seen 10Mbps full duplex in the status. Advanced Settings is not available.

 

And I can't find any other settings either.

The Archer C6 is connected to a FritzBox 6490 via LAN.

 

Another Archer C6 also in AP mode, but shows 1000Mbps full duplex.

 

The speed test confirms this setting.

 

How can I make the Archer C6 faster again?

 

Thank you for the help and sorry for my bad english.

 

 

Regards

 

 

  0      
 
  0      
 
#1
Options
1 Reply
Re:Archer C6- in AP-Mode: Speed through router is capped at 10Mbps
2022-12-05 17:27:03 - last edited 2022-12-05 20:23:25

  @Knallfrosch 

 

Use another LAN port on the FritzBox side, where the problematic Archer C6 is connected.

If the issue persists change the ethernet cable of the problematic Archer C6 with a prooved good one (Cat 5e/6).

 

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 412

Replies: 1

Tags

Access Point Mode
About Us
Press
Copyright © TP-Link Corporation Limited. All rights reserved.