please no support for Dlink DIR-825M :(
my device is DLINK DIR-825M HW: A1 (soc: RTL8367RB)
i want to get U-BOOT ... because it breaked :(
i contact to D-LINK but no support :( really no support)..
i only want to re flash it with the origin firmware but no boot on it...
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Serial Info:
Booting...
init_ram
bond:0x00000005
MCM 128MB
dram_init_clk_frequency ,ddr_freq=1066 (Mbps), 533 (MHZ)
DRAM init disable
DRAM init enable
DRAM init is done , jump to DRAM
enable DRAM ODT
SDR init done dev_map=0xb8142000
Detect page_size = 2KB (3)
Detect bank_size = 8 banks(0x00000002)
Detect dram size = 128MB (0x08000000)
DDR init OK
init ddr ok
DRAM Type: DDR2
DRAM frequency: 533MHz
DRAM Size: 128MB
- Copy Link
- Report Inappropriate Content
i want U-Boot
- Copy Link
- Report Inappropriate Content
It seems you are asking in the wrong community. This is the TP-Link official community, it's not the D-LINK community.
Since your device model is D-LINK, you can ask for suggestions in their community.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 437
Replies: 3
Voters 0
No one has voted for it yet.