Apple devices cannot connect to M4: "incorrect password for [wifiname]
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.Apple devices cannot connect to M4: "incorrect password for [wifiname]
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have setup a mesh with 5 Deco M4 throughout the house. On the 2 most remote ones my apple devices (both iphone and ipad) regularly tell me that they cannot connect because I have the wrong password for the wifi (which is clearly not the case, as they connect normally elsewhere). Essentially makes the use of Wifi with those devices impossible.
I have disabled the "fast roaming" feature, and relearned the network on all devices.
Any idea anyone?
//D
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Right
i have just run an ethernet lead to the deco in the middle of the house and set this as the main
this means the other 3 are all connected to the main
previously 2 connected to main and 1 fed off a satellite- it was this one the apple phones and pads wouldnt accept the password
its now working fine
apple phones and pads will connect to any deco connected directly to the main
- Copy Link
- Report Inappropriate Content
I observed the exactly same thing - unfortunately I cannot connect to one central hub as this distance is too much. This defies the concept of a mesh network. As long as tp-link doesn't fix this I can definitely not recommend this hardware, and will send it back.
- Copy Link
- Report Inappropriate Content
I have exactly the same issue with my iPhones and the Deco X20's and later added a Deco X50.
I noticed that the firmware of the X50 is quite recent "20230620" but the firmware for the X20's is from "20210204"? Is this correct?
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1376
Replies: 14
Voters 0
No one has voted for it yet.