Home Network Community > DSL Modem Routers > Need configuration for Bandwidth Control on XC220-G3v
< DSL Modem Routers

Need configuration for Bandwidth Control on XC220-G3v

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Need configuration for Bandwidth Control on XC220-G3v

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Need configuration for Bandwidth Control on XC220-G3v
Need configuration for Bandwidth Control on XC220-G3v
2023-08-20 08:23:36 - last edited 2023-08-21 01:13:48
Model: Archer VR1200  
Hardware Version: V2
Firmware Version: 1.2.0 0.8.0 v6062.0 Build 220907 Rel.7774n

Hi Team,

 

I have TP-Link router XC220-G3v (Please note, I selected wrong model in drop down as my model is not available.) and internet speed plan is of 100Mbps. Out of this, I want to dedicate 60Mbps to one of the laptop device and remaining bandwidth can be utilized by all other devices.

There is a QoS section in advanced setting. Please find below snapshot of same. But unable to understand how to use same. Kindly help.

  0      
 
  0      
 
#1
Options
2 Reply
Re:Need configuration for Bandwidth Control on XC220-G3v
2023-08-23 09:15:09

  @BS7 

 

Upon checking, your modem router XC220-G3v is ISP specialized model. As the parameters may be different from the generic router and we are not familiar with it. So to solve the issue more efficiently, it suggests you contact your internet service provider to guide you set up this modem router.

 

If it was purchased from regular store instead of your ISP, please contact the local technical support team in your area:

Contact | TP-Link

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.
  0  
  0  
#2
Options
Re:Need configuration for Bandwidth Control on XC220-G3v
2023-11-05 09:36:53
Hello. Did you manage to set it up? I have the same problem..
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 1034

Replies: 2

Related Articles
 how to configure control bandwidth in this device?
627 0
 Bandwidth Control Rules Configuration
639 0
Router with Bandwidth Control?
3235 0
 configuration bandwidth
387 0
 I need configuration
218 0
Bandwidth control options
175 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.