RE300 & ax73 | OneMesh doesn't work

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

RE300 & ax73 | OneMesh doesn't work

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
RE300 & ax73 | OneMesh doesn't work
RE300 & ax73 | OneMesh doesn't work
2023-10-18 14:37:06 - last edited 2023-10-20 09:40:47
Model: RE300  
Hardware Version: V1
Firmware Version: 1.0.8 Build 20211126 Rel.678447

Can't connect RE300 to ax73 as OneMesh. RE300 in Tether is stating that "main router is not supporting OneMesh". According to specification both devices are supporting OneMesh.

  0      
  0      
#1
Options
1 Accepted Solution
Re:RE300 & ax73 | OneMesh doesn't work-Solution
2023-10-18 19:28:09 - last edited 2023-10-20 09:40:47

  @nenow 

 

Have you tried to add tre RE300 in OneMesh through the AX73 WebGUI like this:

 

 

You can also use the WPS button method or use this video setup for configuring through a web browser.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
Recommended Solution
  4  
  4  
#2
Options
2 Reply
Re:RE300 & ax73 | OneMesh doesn't work-Solution
2023-10-18 19:28:09 - last edited 2023-10-20 09:40:47

  @nenow 

 

Have you tried to add tre RE300 in OneMesh through the AX73 WebGUI like this:

 

 

You can also use the WPS button method or use this video setup for configuring through a web browser.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
Recommended Solution
  4  
  4  
#2
Options
Re:RE300 & ax73 | OneMesh doesn't work
2023-10-19 06:05:01

  @terziyski Thanks for support. After RE300 reset to factory and connection via WPS, than your method, finally is connected as OneMesh :)

  1  
  1  
#3
Options