Deco X60 after FW Upgrade many wifi devices are disconnected
Hi,
so after the latest upgrade the wifi network is unstable devices are disconnected,
communications between Deco's are disconnected.
this make my wifi network unstable.
i have set of 3 decos X60 V2
any solution?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
i had many unstable issues on 1.5.2
and we downgraded back to 1.5.1
i am using test FW of 1.5.2 look stable for a while
1.5.3 i have not tested yat need to look what are the changes
- Copy Link
- Report Inappropriate Content
after that whole mess of upgrade from 51 to 52, I ultimately downgraded to firmware 50 since that's what was available on the website. And all my problems went away.
I'm not sure where to get a hold of 51, or I probably would've rolled back to that.
But firmware 52 was a nightmare. I really don't understand why it took so long to get fixed when so many people experienced the problem.
Until this issue, I actually trusted TPLink. I have all my light switches and dimmers, managed switch, and decos. Not that I don't expect there to be problems, but a problem as big as this should've been fixed right away.
- Copy Link
- Report Inappropriate Content
Hi,
I had the same issue with my smart home started to see in Home Assistants devices that disconnected period of times
issue with connecting and moving between units
also the communication between units was so bad, i found the version in TP link website but any why if you rollback to 50 this is just fine
i will try to do some testing on the new FW that was relesed i will update the thread here if its ok to upgrade
- Copy Link
- Report Inappropriate Content
How did the latest work for you? I was still running into times where my wifi got very laggy.
- Copy Link
- Report Inappropriate Content
Hi,
i have recently upgraded to 1.5.3 build 20231227 rel.62665
and i have disabled beamforming, so far look stable there was 1 time that i did reboot because its was stuck,
one more thing i have notice that if the deco connected wireless so the connection between the units are very poor even the distance is not so far,
i had the options to connect them over eth so i did so but its suck situation.
whats new at your side?
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 2107
Replies: 25
Voters 0
No one has voted for it yet.