Home Network Community > SOHO Switches > Issues with LS1005G and LS1008G switches
< SOHO Switches

Issues with LS1005G and LS1008G switches

Issues with LS1005G and LS1008G switches

Issues with LS1005G and LS1008G switches
Issues with LS1005G and LS1008G switches
2024-01-24 02:20:42 - last edited 2024-01-26 01:07:30
Model: LS1005G   LS1008G  
Hardware Version:
Firmware Version:

Hi all 

 

I'm having issues with 2xLS1005G and 1xLS1008G switches which is effecting my upload speed and idle, download and upload latency (results taken from https://www.speedtest.net/) yet, if I unplug these 3 switches my upload speed and idle, download and upload latency aren't to much different if I've ran the speed test directly from the router.

 

My ISP speeds are 150mbps for both upload and download.

 

My set up was, in the front room, a Netgear XR500 was connected to a LS1005G which connected direct to a Powerline and a TP-Link Archer C80 AC1900 in AP mode.

 

Bedroom 2 ran a Powerline to a LS1008G switch which was connected to a Personal Laptop, Work Laptop and PS5, and to an 2nd TP-Link Archer C80 AC1900 in AP mode.

 

Bedroom 3 ran a Powerline to a LS1005G switch which was connected to a PS4, and to an 3rd TP-Link Archer C80 AC1900 in AP mode.

 

And the speeds I was getting was:

 

 

But every since I've took them out, my speeds are looking like this:

 

Anyone know why I'm getting such a difference in performance when I've got the switches in?

 

  0      
 
  0      
 
#1
Options
3 Reply
Re:Issues with LS1005G and LS1008G switches
2024-01-24 08:46:37

  @DarkSmoggie 

 

When you have the switches plugged in there's a 0.7% packet loss, ping delay and jitter are higher.

To troubleshoot this issue you can do the following:

Plug in the switches one by one starting from Bedroom 3, then Bedroom 2 and finally the front room while doing the speed tests on every step.

Thus you could pinpoint the switch that is causing the issue.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  1  
  1  
#2
Options
Re:Issues with LS1005G and LS1008G switches
2024-01-26 01:06:57

  @terziyski Might have sorted the issue, as I mentioned in my OP that I disconnected the switches from the AP's, well I reconnected one of the switches, and then the problem started again, but after turning off the main router, unplugging the Ethernet cables from the powerlines, also turning off the AP and taking out the power lead of the switch that was in bedroom 3 I put back in, I switched them on one by one waiting till they settled down and then switching the next one on in order, front room AP, then bedroom 2 AP, the bedroom 3 AP, and then the bedroom 3 switch, the upload speed and idle, download and upload latency pretty much matched what I would have got if plugged into the router, I then switched off the bedroom 2 AP, attached the 8 port switch, switched the bedroom 2 AP back on after a few minutes, let it settle, plugged in the lead to the 8 port switch and still got near enough the same results as if I had plugged it into the router

  0  
  0  
#3
Options
Re:Issues with LS1005G and LS1008G switches
2024-01-26 01:41:47

  @DarkSmoggie 

 

Well done. For that kind of troubleshooting I was talking about.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#4
Options

Information

Helpful: 0

Views: 369

Replies: 3

Related Articles
LS1005G switch
3267 1
LS1008G dropping significant speed
790 0
Issues with LS1005G
1456 0
Power LS1005G with TL-POE10R
426 0
Deco S7 and Switch LS1005G
98 0
TL-SG105 vs. LS1005G
10065 0
About Us
Press
Copyright © TP-LINK CORPORATION PTE. LTD. All rights reserved.