How to manually select which deco node to connect to each other?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How to manually select which deco node to connect to each other?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How to manually select which deco node to connect to each other?
How to manually select which deco node to connect to each other?
2024-03-20 08:27:51 - last edited 2024-03-21 08:16:32
Model: Deco X50  
Hardware Version: V1
Firmware Version: 1.4.1 build 20231122 Rel.40485

I have a problem,

my house having 3 floors, 

I setup the main node in the 1st floor.

bedroom in 2nd floor

my working room in 3rd floor

 

The problem is both 2nd, 3rd node in 2nd and 3rd floor is connecting to the main node in 1st floor, instead of 1 to 2 and 2 to 3.

So the signal from 1 to 3 is very weak, from 1 to 2 is good. With slow signal, my connection is weak too on the 3rd floor.

 

How to I can manually setup it can be connect 1 to 2 and 2 to 3 ?

 

  0      
  0      
#1
Options
1 Accepted Solution
Re:How to manually select which deco node to connect to each other?-Solution
2024-03-20 11:53:58 - last edited 2024-03-21 08:16:32

  @KieuNhat 

 

See this TP-Link FAQ, which will provide the solution: Connection Preference: Customize Your Preferred Signal Source

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:How to manually select which deco node to connect to each other?-Solution
2024-03-20 11:53:58 - last edited 2024-03-21 08:16:32

  @KieuNhat 

 

See this TP-Link FAQ, which will provide the solution: Connection Preference: Customize Your Preferred Signal Source

Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 366

Replies: 1

Related Articles