eero Pro 6E router causes AX73 to endlessly reboot
I have been given an eero Pro 6E router by my ISP and immediately got the details so I could use my AX73 due to the lack of ability to do anything with the eero app. What I want to do is use the bridge mode on the eero router to act as a wireless access point, but every time I connect the eero router when in bridge mode it causes the AX73 to endlessly reboot. If I factory reset the eero it's fine as it defaults to full router mode, but if I turn on bridge mode the same thing happens.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi,thanks for posting question on our community.
May I confirm that your network topology is Archer AX73--eero router (AP mode) or eero router(bridge)---AX73? I got a little confused according to your description.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
I have the modem details as well if that's of use.
Modem (ADTRAN SDX 621i) -> (WAN port) TP Link AX73 Router (LAN) -> eero Pro 6e (in bridge mode)
- Copy Link
- Report Inappropriate Content
Hi, thanks for your detailed information.
As I understand it, I will set up eero Pro 6e router as Access Point mode instead of bridge mode.
- Copy Link
- Report Inappropriate Content
Hi,
I think for the eero AP mode is bridge mode. I've attached a couple of screenshots of the options.
- Copy Link
- Report Inappropriate Content
Make sure you give them different DCHP addies as well, so change at least one of them preferably both of them from the 192.168.0.1 etc to say 192.168.55.01 & 192.168.55.02 for instance (use your own numbers not my examples), make sure the pool numbers aren't in the connected devices pool either for connected clients so set your range to be outside of the router/s dchp pool.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 583
Replies: 6
Voters 0
No one has voted for it yet.