Business Community > Controllers > connected devices not showing up in client list
< Controllers

connected devices not showing up in client list

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

connected devices not showing up in client list

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
connected devices not showing up in client list
connected devices not showing up in client list
2024-07-14 14:09:12
Model: OC200  
Hardware Version: V1
Firmware Version: 1.29.4

Have a TL-R605 v1.0 router and T1600G-52PS v4.0 switch that are directly connected to the devices that are not sowing up.

I have a CPE510(a) that is connected to the T1600G-52PS v4.0 switch not showing connected anywhere in the client list, there is another CPE510(b) connected on the wireless side of the CPE510(a) the clients tha t are connected to a SG2008P v3.20 switch on the wireless side are showing the clients connected.

Why is the CPE510 devices not showing up

 

 

 

Thanks you any help

  1      
 
  1      
 
#1
Options
3 Reply
Re:connected devices not showing up in client list
2024-07-15 06:39:26

  @rebelbah 

I am confused. Could you please draw a diagram of your network and point out the problem for me? Do you assign a static IP address to the CPE unit? If it has a static IP, it will not appear on the client list.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options
Re:connected devices not showing up in client list
2024-07-15 12:04:04

  @Hank21 

yes those 2 devices are static, that should not stop it from showing up in the client list, other devices such as cameras that are on a static is showing in the client list(cameras are on a different IP range)

I have access to other brand systems that show static devices in the client list did not think they omitted them here.

I think they should have them listed or at least allow you to have access a reservations list 

 

 

 

  0  
  0  
#3
Options
Re:connected devices not showing up in client list
2024-07-17 01:43:45

  @rebelbah 

To see if they can appear on the client list, you can attempt to connect the CPE(a) directly to the TL-SG2008P controlled by the controller and let it obtain an IP address from the router without setting it as static.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#4
Options

Information

Helpful: 1

Views: 390

Replies: 3

Related Articles
Devices showing as "Connected" in the controller client list, but have been disconnected for hours
2084 0
 AP's showing as connected but not showing in "Access points" list
1394 0
Cant Find Known Connected Device in Device List
270 0
Hundreds of Unknown Mac Address devices appear on LAN client list
1129 0
 New ER7206 router, some devices not showing up on dhcp client list
207 0
 List currently connected devices
3224 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.