TPLink Archer c6 v2 QoS not showing Downlink speed

TPLink Archer c6 v2 QoS not showing Downlink speed

TPLink Archer c6 v2 QoS not showing Downlink speed
TPLink Archer c6 v2 QoS not showing Downlink speed
2024-07-30 15:45:04
Model: Archer C6  
Hardware Version: V2
Firmware Version: 1.1.8 Build 20210226 rel.34930(5553)

The router's software isn't showing the downlink speeds for any devices connected to it. It only shows the uplink speeds and it only measures upload data consumption. Download consumption is not measured.

So is it a problem with the firmware or the router. Router configuration is ok. 

 

In the attached screenshot, Clients: IMPULSER is  downloading (that is at 15 MB/s [Megabytes/sec]) still you can see that it isn't displaying downlink speeds rather showing only upload speeds.

 

download scenario:

download casse

 

upload sceanrio:

 

upload case

 

  1      
  1      
#1
Options
1 Reply
Re:TPLink Archer c6 v2 QoS not showing Downlink speed
2024-07-31 00:00:00 - last edited 2024-07-31 00:02:26

  @rajesh176 

 

This looks like an issue from an old thread - here.

The only way to be sure that this is a FW issue is to do the following:

1. Make notes about your router configuration (for example in Notepad).

2. Create a router configuration backup file using the Backup feature.

3. Hard reset the router using the reset button on the back panel (hold it for about 10 seconds).

4. Instead restoring from a backup file - configure the router from scratch (only basic settings) using your notes (from step 1).

5. Test and check if there's any improvement. If there is - make sure you have restored all previous settings from your notes and stop here.

6. If there's no improvement you can restore the router configuration from the backup file (from step 2) using the Restore feature.

If this was helpful click once on the arrow pointing upward. If this solves your issue, click once the star to mark it as a "Recommended Solution".
  0  
  0  
#2
Options