No longer works as WiFi bridge
I have a camera far away from my house. To connect it, I have this AP which connects via WiFi (mesh) to another AP. It's then connected to the PoE dongle from the box, which is in turn connected to the camera.
This has worked great for a long time, until I recently updated the firmware on my AP. I'm not sure which version exactly introduced the issue, but I experienced the issue on version 1.3.1
After downgrading to 1.2.5, it is working as expected again.
The symptoms goes like this:
* AP Connects via WiFi, and stays connected for a minute or so.
* Then the WiFi symbol disappears from the status column, and when checking Mesh config, it says that the AP is connected by wire.
* Then it misses a heartbeat, and then gets Isolated status.
After a bit, it connects again and the cycle starts over.
