Home

Forums

Stories

Knowledge Base

Home Network Community > Adapters > TX201 v1.0 2.5GbE slower than my onboard 1000mbps connection

< Adapters

TX201 v1.0 2.5GbE slower than my onboard 1000mbps connection

Patar

2024-10-09 21:14:18 - last edited 2024-11-14 11:11:50

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-10-09

TX201 v1.0 2.5GbE slower than my onboard 1000mbps connection

2024-10-09 21:14:18 - last edited 2024-11-14 11:11:50

Tags: #2.5 Gbps

Model: TX201

Hardware Version: V1

Firmware Version: 10.56.119.2022

I've installed a TX201 adaptor in my PC (the onboard is a 100/1000 port) thinking I'd take advantage of improved speed of my home network (TP-link Deco BE65, 2.5GbE ports) and internet connection (2000/2000 fibre connection), but doing a speed test now shows I'm now getting 450/450Mbps, whereas previously I was getting 950/700Mbps. This effect is visible by running speed tests one after the other and swapping the ethernet cable between the ports.

The TX201 is showing that the network is a 2.5GbE connection, so I'm not sure what's going on. Any suggestions?

I should note that I tried running a speed test on measurementlab and using the onboard ethernet I get retransmission rates <0.3%, but using the TX201 I get a retransmission rate >25%

1 Accepted Solution

Sunshine

2024-10-13 09:54:48 - last edited 2024-11-14 11:11:50

Posts: 7375

Helpful: 1221

Solutions: 941

Stories: 0

Registered: 2018-12-17

Re:TX201 v1.0 2.5GbE slower than my onboard 1000mbps connection-Solution

2024-10-13 09:54:48 - last edited 2024-11-14 11:11:50

@Patar

Hi,

Is it directly connected to the main Deco?

Please also provide the following information for us to check:

1. The network topology.

2. The screenshots of the speed test results and the retransmission rate result.

3. The specification of your Ethernet cable and the computer operation system.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode. If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.

Recommended Solution

Marvin_S

2024-11-14 11:33:56

Posts: 2243

Helpful: 165

Solutions: 385

Stories: 0

Registered: 2022-05-09

Re:TX201 v1.0 2.5GbE slower than my onboard 1000mbps connection

2024-11-14 11:33:56

@Patar

Hi, to assist you efficiently, I've forwarded your case to the TP-Link support engineers who will contact you with your registered email address later. Please pay attention to your email box for follow-up.

Check Out the Latest Posts: Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability. TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode.

MikeOz77

LV1

10 hours ago - last edited 9 hours ago

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-12-22

Re:TX201 v1.0 2.5GbE slower than my onboard 1000mbps connection

10 hours ago - last edited 9 hours ago

@Marvin_S

Hi Marvin - I'm having the exact same issue on my end.

I have a TX201(UN) v1.0 PCIe Network Adaptor. Driver = 1125.7.318.2022. PC is running Windows 11 latest. Cat 8 Ethernet cable.

The speed at my gateway is about 1.8GBps but only getting around 500-600MBps on the PC with this network card. I have a direct wired connection to the gateway.

Looking for some help as it seems somehow specific to this network adaptor.

Thanks!

Mike

TX201 v1.0 2.5GbE slower than my onboard 1000mbps connection

TX201 v1.0 2.5GbE slower than my onboard 1000mbps connection

Information

Voters 0

Tags