Hi! @terziyski 

Thanks for the quick response and for confirming that there aren’t any known issues with the update. That’s reassuring!
 

I wanted to ask a bit more specifically about the wireless range. After applying the new firmware update, have you or anyone else noticed any change in range coverage on either the 2.4 GHz or 5 GHz bands? I’m particularly concerned about any decrease in range that might affect coverage in larger areas of my home.

Thanks again for the help!

Best regards,
Zubaer

A have Smartconnect problem. On 1.13.15 and on beta 1.14.3:

once android\phone device connected to 5Ghz, then move to low signal zone, connect switched to 2.4Ghz and keep slow 2.4ghz link all the time, even standing straight ahead the router it WONT switch back to 5Ghz. 

 Hello @YuriyB,  
Does this issue occur only when the Archer C64 is used as a repeater? After the update, I haven't encountered any problems so far.

  @ZubaerAhmad-XI 

in any mode. sdandalone, repeater, easymesh

Did you enabled smartconnect?

pleasy try move to weak signal zone so your device will switch from 5 to 2.4ghz.

and then go back to check whether it will switch back to 5ghz or will keep slow 2.4ghz

  @YuriyB Yes, I enabled the SmartConnect feature and encountered the same problem in Router mode. The devices did not switch from the 2.4 GHz to the 5 GHz band consistently. However, it does not seem to happen all the time. Additionally, the update notes mentioned that the speed displayed on the client page for devices is either inaccurate or shows a very low value. After installing the update, I conducted a multi-connection test on Speedtest.net, which reported speeds of over 800 Mbps. However, during the test, the router displayed values ranging from 0 Kbps to 300 Kbps. This indicates that the bug has not been resolved yet.

  @ZubaerAhmad-XI  here's my problem with smartconnect, pls confirm there https://community.tp-link.com/en/home/forum/topic/707852