Installation: EX220 V2 - Mesh - static IP

Installation: EX220 V2 - Mesh - static IP

Installation: EX220 V2 - Mesh - static IP
Installation: EX220 V2 - Mesh - static IP
Thursday
Model: EX220  
Hardware Version: V2
Firmware Version: 2.8

Can anyone tell me how to configure the 5 EX220 V2 units with the requirements below?

 

- I have a server with DHCP Server and I can assign IPs associated with the MAC Addresses of the network equipment.

- My network is 192.168.0.0/16 (yes, I use class B for the 192.168.0.0 network)
- My network mask is 255.255.0.0 (class B)
- I set a fixed IP on the EX220 controller using IP 192.168.10.240 mask 255.255.0.0
- I associated the MAC Addresses of the 04 Client units to the IPs in the following sequence:
- 192.168.10.239/16
- 192.168.10.238/16
- 192.168.10.237/16
- 192.168.10.236/16
- All CLIENTS were reset to default Client through the TP-Link WEB configuration page of each Equipment

 

All clients are connected to a gigabit switch (on the same LAN).

Sometimes, when turned off and on, clients assume the IP 192.168.0.1 and do not get the IP offered by the DHCP Server.

 

 

Is there any way to leave the IP fixed on the clients after they are reset, so that they are recognized by the controller?

 

 

(Controller connected via CAT6a cable to the LAN port of the EX220)
(Clients connected to the WAN port of each EX220)

Marco Varanda Sr Infrastructure Analyst +55-11-983967777
  0      
  0      
#1
Options