Hi Friends,

Even I am facing the same problem as venkat.tadkonda is facing. Recently I have purchased TP link router but it takes long time to glow WAN Led minimum 5 - 10 mins. But when I connect the net wire directly into pc with duplex speed 10 mbps it is working fine. And also the speed is very slow with router. I believe if I change tp link duplex to 10 mbps it will work fine but there is no such setting in tp link router to change duplex speed. I also googled to check if there is any setting to duplex speed but there is no such option.

Below are the steps I did

Hard reset
firmware upgraded

But nothings work even my ISP don't understand the problem. I thought there could be hardware problem and I replaced the same with new one. But nothing worked.

I think my problem will resolve if I change duplex speed of router to 10 mbps because I was facing same problem with pc if I keep duplex speed to auto negation and also one thing that my internet wire directly goes into pc and it's a Hathway cable net.

Please advice

Regards,
Dinesh Pise

Hi Friends,

Even I am facing the same problem as venkat.tadkonda is facing. Recently I have purchased TP link router but it takes long time to glow WAN Led minimum 5 - 10 mins. But when I connect the net wire directly into pc with duplex speed 10 mbps it is working fine. And also the speed is very slow with router. I believe if I change tp link duplex to 10 mbps it will work fine but there is no such setting in tp link router to change duplex speed. I also googled to check if there is any setting to duplex speed but there is no such option.

Below are the steps I did

Hard reset
firmware upgraded

But nothings work even my ISP don't understand the problem. I thought there could be hardware problem and I replaced the same with new one. But nothing worked.

I think my problem will resolve if I change duplex speed of router to 10 mbps because I was facing same problem with pc if I keep duplex speed to auto negation and also one thing that my internet wire directly goes into pc and it's a Hathway cable net.

Please advice

Regards,
Dinesh Pise

I am final, I am sorry, but it is necessary for me little bit more information.

Many isp that uses PPPOE or username and password binds your Mac address ask them to release it. I had the same problem and now after releasing my mac address that was binded by my isp there is no internet caution sign and its working fine. gl

Mac clone funtcion.

I've setup my 740N properly. Currently I don't have any issues. Check out my blogspot, it'll help you select right settings.