IPSEC MR600 + SNAT DNAT OFF

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

IPSEC MR600 + SNAT DNAT OFF

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
IPSEC MR600 + SNAT DNAT OFF
IPSEC MR600 + SNAT DNAT OFF
2025-02-20 13:00:51 - last edited 2025-03-25 03:25:03
Model: Archer MR600  
Hardware Version: V3
Firmware Version:

Hi,

I would like to know if it is possible to configure an IPSEC tunnel between three Archer MR600 V3s with the basic firmware version.
The three links are PPPoE fibers. Second quick question, is it possible to remove the SNAT and DNAT from the MR600?

Thank you for the response

  0      
  0      
#1
Options
1 Accepted Solution
Re:IPSEC MR600 + SNAT DNAT OFF-Solution
2025-02-21 06:15:33 - last edited 2025-03-25 03:25:03

  @EnzoCsn 

 

Hi, welcome to our community.

I am afraid the answer is no for your both questions.

Best regards.

 

Recommended Solution
  0  
  0  
#3
Options
2 Reply
Re:IPSEC MR600 + SNAT DNAT OFF
2025-02-21 00:43:19 - last edited 2025-02-21 00:43:41

Hi @EnzoCsn 

Thanks for posting in our business forum.

You posted this thread on the wrong page. This is business forum and Omada Router page for Omada device discussion. Your model is Archer. I will move your case to the correct page.

  0  
  0  
#2
Options
Re:IPSEC MR600 + SNAT DNAT OFF-Solution
2025-02-21 06:15:33 - last edited 2025-03-25 03:25:03

  @EnzoCsn 

 

Hi, welcome to our community.

I am afraid the answer is no for your both questions.

Best regards.

 

Recommended Solution
  0  
  0  
#3
Options