MAC filtering not working AC750

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

MAC filtering not working AC750

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
MAC filtering not working AC750
MAC filtering not working AC750
2015-08-05 09:25:45
Model :

Hardware Version : Not Clear

Firmware Version :

ISP :

I have an AC 750 dual band wireless router. I have set the MAC address in DHCP/Wireless 2.4Ghz/Wireless 5Ghz and also have selected " Allow the stations specified by any enabled entries in the list to access." for both 2.4 and 5 Ghz. I have checked that all is enabled. The MAC address was copied from the DHCP/DHCP Client List which is the same when I check directly on my computer. Not sure what I am doing wrong but my computer never takes the specified IP address of 192.168.0.100
  0      
  0      
#1
Options
2 Reply
Re:MAC filtering not working AC750
2015-08-05 14:27:20
:confused:Confused...
The Wireless MAC Address Filtering feature allows you to control the wireless stations accessing the AP, which depend on the station's MAC addresses.
But you want to bind MAC address and IP address?
There is IP&MAC binding on a different page, isn't it?
  0  
  0  
#2
Options
Re:MAC filtering not working AC750
2015-08-06 04:54:18
Seams to be working today. I guess you have to wait for the lease to expire. Every time I rebooted the computer the router would assign the same IP address, confirmed by checking the DHCP client list. It also showed the the lease expiry time was two hours which would reset everything the computer was rebooted. Now it's almost 24 hours later so I guess that lease finally expired. I guess I could have tried rebooting the router. Maybe the would have reset the leases. Thanks for the reply.
  0  
  0  
#3
Options