Home Network Community > Range Extenders > It doesn't work
< Range Extenders

It doesn't work

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

It doesn't work

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
It doesn't work
It doesn't work
2025-06-15 23:53:05 - last edited 2025-07-07 01:31:26
Model: RE200  
Hardware Version: V1
Firmware Version: A8-42-A1-35-72-0E

The device doesn't work for me after the adapters from restarting

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:It doesn't work-Solution
2025-06-16 07:46:06 - last edited 2025-07-07 01:31:26

Hi@Majed_1993,

Thank you for contacting our community.

 

May I know what is the LED status of the RE200 now?  You can hard reset the RE200 for a try: With the power on, press the reset hole for 1 sec.

Then configure the RE200 as below: How to Set Up TP Link Range Extender RE200 & RE220 via Tether App

Welcome to Our Community！ Check Out the Latest Posts: △New Firmware for Archer BE800 V1 to Support VPN Merge, EasyMesh Guest/IoT Network Extend, and More △Enhanced EasyMesh Support with Extended Guest/IoT/MLO Networking and Advanced Features for BE550 V2 △New Firmware for Archer BE900 V2 to Support Multi-WAN, DoH/DoT, EasyMesh in AP Mode and More △New Firmware for Archer BE260/Archer BE400 to Support VPN Merge, New ECO Mode, and More If you found the post or response helpful, click Helpful. If an answer solves your problem, click Recommended Solution so that others can benefit from it.
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:It doesn't work-Solution
2025-06-16 07:46:06 - last edited 2025-07-07 01:31:26

Hi@Majed_1993,

Thank you for contacting our community.

 

May I know what is the LED status of the RE200 now?  You can hard reset the RE200 for a try: With the power on, press the reset hole for 1 sec.

Then configure the RE200 as below: How to Set Up TP Link Range Extender RE200 & RE220 via Tether App

Welcome to Our Community！ Check Out the Latest Posts: △New Firmware for Archer BE800 V1 to Support VPN Merge, EasyMesh Guest/IoT Network Extend, and More △Enhanced EasyMesh Support with Extended Guest/IoT/MLO Networking and Advanced Features for BE550 V2 △New Firmware for Archer BE900 V2 to Support Multi-WAN, DoH/DoT, EasyMesh in AP Mode and More △New Firmware for Archer BE260/Archer BE400 to Support VPN Merge, New ECO Mode, and More If you found the post or response helpful, click Helpful. If an answer solves your problem, click Recommended Solution so that others can benefit from it.
Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 186

Replies: 1

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.