Can't add ER706WP-4G to my OC 200

Dear TP-Link team,
I connected my new ER706WP-4G to my network. I ran through the intitial setup to setup the admin account. Unfortuantely my OC200 refuses to see my new device and add it. Am I missing something?
Thanks!
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content

Hi @Cepheus0815
What the controller's IP address? and what's the router's IP address?
To add a router to an exiting network, please refer to the following guide:
How to add an Omada Gateway to the network? (Controller 4.4.3 or above)
If the issue persist, please refer to the following to do some troubleshooting:
What should I do when the Omada Software Controller (V4) fails to discover the devices?
- Copy Link
- Report Inappropriate Content
Whats your controller version ?
You need at least Omada Controller 5.15.20.38 (firmware V1_1.35.5 for OC200 v1 or firmware V2_2.20.5 for OC200 v2).
- Copy Link
- Report Inappropriate Content
Hi @n0sh1t ,
Thanks for the reply. I use the latest version for OC200: 1.35.7 Build 20250514 Rel.51837 (Stable)
Thanks, Rainer
- Copy Link
- Report Inappropriate Content

Hi @Cepheus0815
What the controller's IP address? and what's the router's IP address?
To add a router to an exiting network, please refer to the following guide:
How to add an Omada Gateway to the network? (Controller 4.4.3 or above)
If the issue persist, please refer to the following to do some troubleshooting:
What should I do when the Omada Software Controller (V4) fails to discover the devices?
- Copy Link
- Report Inappropriate Content
Thanks everyone, I was finally abl to add the gateway.
- Copy Link
- Report Inappropriate Content

Information
Helpful: 0
Views: 242
Replies: 4
Voters 0
No one has voted for it yet.