Home Network Community > Wi-Fi Routers > C64 Led control doesnt work properly- it turns on after reboot
< Wi-Fi Routers

C64 Led control doesnt work properly- it turns on after reboot

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
12

C64 Led control doesnt work properly- it turns on after reboot

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
11 Reply
Re:C64 Led control doesnt work properly- it turns on after reboot-Solution
2025-08-12 01:36:18 - last edited 2025-09-04 10:24:30

Hello@YuriyB ,

You mean turning on night mode will make the LED control take effect, right?

For details about LED control, you can refer to How should I manage the LED Control of my TP-Link router and range extender?

Welcome to Our Community！ Check Out the Latest Posts: △New Firmware for Archer BE400 V1 to Support IPv6 VPN, Wake On LAN, and More △New Firmware for Archer BE800 V1 to Support VPN Merge, EasyMesh Guest/IoT Network Extend, and More △Enhanced EasyMesh Support with Extended Guest/IoT/MLO Networking and Advanced Features for BE550 V2 △New Firmware for Archer BE900 V2 to Support Multi-WAN, DoH/DoT, EasyMesh in AP Mode and More If you found the post or response helpful, click Helpful. If an answer solves your problem, click Recommended Solution so that others can benefit from it.
Recommended Solution
  0  
  0  
#12
Options
12
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.