why satellite is not broadcasting MLO signal
Hi all
I am using be900 as the main router connected to internet, be550 is using wired backhaul connected to be900 as a easymesh satellite.
if I disable MLO, I can get highest signal near satellite be550 with full speed, but if I enable MLO i cannot get any signal from satellite.
Appreciate anyone can help please.
Regards
Lewis
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hello @lewisc ,
Thanks for getting back to me.
To check client connection status, you can access the Satellite Router web UI to confirm which clients are connected to the Satellite Router.
Please refer to How to log in the Web interface page of the EasyMesh satellite router.
You can also compare the client information, including signal strength, etc.
It's very likely that after the main router enabled the MLO network, some devices on the Satellite router automatically connected to the MLO network, causing you to perceive a weakening signal from the Satellite router.
There is currently no news regarding the progress of extending the Satellite router's MLO network. We suggest you keep an eye on firmware updates and official website announcements.
- Copy Link
- Report Inappropriate Content
Hello@lewisc ,
Welcome to our community.
Is the satellite router Archer BE550 Pro? Please provide the hardware and firmware versions.
How far is the satellite router from the main router?
Do you mean that if you enable the MLO network on the main router, you cannot detect the satellite router's network? Or you will fail to connect to its network?
- Copy Link
- Report Inappropriate Content
Hi @Joseph-TP
Thanks for your reply.
HW: BE900 v2.0
firmware: 1.1.7 build 20250529 release.12784
BE550 (not pro)
firmware: 1.1.2 build 20250317 release.18331
The satellite router is connected to main router by lan cable with concrete wall between and around 25 meters away.
If I disable MLO, I can get strong signal (likely from satellite) otherwise the signal is very weak.
I found some articles in the discussion board says there will be firmware update to let satellite router mesh MLO signal later, is that the case ? if so is there a timeline for this as the threads were from a year ago.
- Copy Link
- Report Inappropriate Content
Hello @lewisc ,
Thanks for getting back to me.
To check client connection status, you can access the Satellite Router web UI to confirm which clients are connected to the Satellite Router.
Please refer to How to log in the Web interface page of the EasyMesh satellite router.
You can also compare the client information, including signal strength, etc.
It's very likely that after the main router enabled the MLO network, some devices on the Satellite router automatically connected to the MLO network, causing you to perceive a weakening signal from the Satellite router.
There is currently no news regarding the progress of extending the Satellite router's MLO network. We suggest you keep an eye on firmware updates and official website announcements.
- Copy Link
- Report Inappropriate Content
Hello @lewisc ,
We are delighted to announce the pre-release firmware for the Archer BE900 V2! This update has new advanced features. It is recommended that you try this firmware and take advantage of the new features.
New Firmware for Archer BE900 V2 to Support Multi-WAN, DoH/DoT, EasyMesh in AP Mode and More
Any feedback and suggestions are welcome~
- Copy Link
- Report Inappropriate Content
Thanks for the heads up, I just tested the new firmware 2026jan there are no improvement ie. Satellite are not providing MLO signal.
- Copy Link
- Report Inappropriate Content
Hi @lewisc ,
Please note the added EasyMesh Improvements:
(a) Add support for EasyMesh in AP Mode (as a main router)
(b) Added support for web-based management in EasyMesh satellite mode
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 572
Replies: 6
Voters 0
No one has voted for it yet.